Installation guide

Step 5 (Local console)

Connect the keyboard to the KVM Switch. If you have an AT type keyboard, you will need an AT

to PS/2 adapter.

Step 6 (Local console)

Connect the mouse to the KVM Switch.

Step 7

Each PC port connector is HDDB15 -pin type. Locate your input cable. It will have an HDDB15 -

pin male connector at one end. Plug it into any label computer port on the rear of KVM switch

unit. The other end of input cable will have three connectors: a HDDB15 -pin male type for PC

video, a Mini Din 6 pin female type for keyboard and a Mini Din 6 pin female type for mouse. To

plug these three con nectors into the respective ports of computer. Repeat the same procedure to

all of PCs.

Step 8

Double-check all of the connections. You can check the color of keyboard and mouse connector

to make sure the keyboard and mouse cables go to the correct ports.

Step 9

Repeat step 5 to 7 for the remainder of the computers.

Step 10 (Option)

Connect the type A connector of USB A -B cable to the USB port of the host system, while using

remote mass storage control. USB type A plug of USB A -B cable to the computer.