User`s guide

-
23
-
Trouble Shooting
General Problems
Q: The OSD menu does not display a “¤ “
on a channel
where a computer is connected and powered up.
What do I do?
A: ?DKVM-8E will updated “¤
“ every 2 seconds. Using hot
key to access the OSD menu again and it should
have re-detected all the active channels.
Q: When cascading the MASTER unit
does not see the
slave unit(s).
A: ?
Refer to the Installation section for information on how
to properly connect the daisy-chain cable.
?Make sure the daisy-
chain cable that you are using is
right. Using any other cable will not guarantee
proper operation or video quality.
?
Reset the all slave unit first and then reset master unit
to get the lost slave unit.
?
Although a power supply is not necessary to make the
slave unit work, try adding a power supply.