User Manual

DIS-200G Series Industrial Gigabit Ethernet Smart Managed Switch
129
Health Diagnostic
This window is used to display Health Diagnostics information, Discovered Surveillance Devices
information, and initiate a cable distance test on all or selected ports on the Switch. For each link-up port,
the system will check the link status, PoE status and error counters periodically. This page will refresh
every 30s.
To view the following window, click Health Diagnostic, as shown below:
Guide The fields that are displayed in the table are described below:
Parameter Description
Port
This field displays the Ethernet port number.
Loopback Detection Status
This field displays the Loopback Detection
status on the Ethernet port. It can be one of the
following:
Normal - No loop is detected on the port.
Loop - A loop is detected on the port.
Cable Link
This field displays the cable link status. It can
be one of the following:
PASS - The port link is up and operating in the
full-duplex mode.
10M Half - The port link is up and operating at
10 Mbps speed and in the half-duplex mode.
100M Half - The port link is up and operating at
100 Mbps speed and in the half-duplex mode.
PoE Status
This field displays the PoE status. It can be one
of the following: PASS, PD Short, Overload,
Power Denied, Thermal Shutdown, or
Classification Failure.
Figure 12-18 Health Diagnostic window