User Manual

DIS-200G Series Industrial Gigabit Ethernet Smart Managed Switch
101
Web Authentication
This window is used to view and configure the Web authentication settings.
To view the following window, click Security > Web-based Access Control > Web Authentication, as
shown below:
The fields that can be configured are described below:
Parameter Description
Web Authentication State
Select to enable or disable the Web authentication feature’s global
state.
Trap State
Select to enable or disable the Web authentication feature’s trap
state.
Virtual IPv4
Enter the virtual IPv4 address used here. The virtual IP of Web
authentication is just the characterization of the Web authentication
function on the Switch. All Web authentication processes
communicate with this IP address; however, the virtual IP does not
respond to any ICMP packet or ARP request. So, it’s not allowed to
configure virtual IP in the same subnet as the Switch’s IP interface
or the same subnet as the host PCs’ subnet, otherwise the Web
authentication cannot operate correctly. If the IPv4 virtual IP is not
configured, the IPv4 access cannot start a Web authentication.
Virtual IPv6
Enter the virtual IPv6 address used here. If the IPv6 virtual IP is not
configured, the IPv6 access cannot start a Web authentication.
Redirection Path
Enter the redirection path here. This path can be up to 128
characters long.
Figure 8-14 Port Security Global Settings window