User Manual

DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
67
This command is used to display the MAC address table’s aging time.
Example
This example shows how to display the MAC address table’s aging time.
Switch# show mac-address-table aging-time
Aging Time is 300 seconds
Switch#
13-8 show mac-address-table learning
This command is used to display the MAC-address learning state.
show mac-address-table learning [interface INTERFACE-ID [, | -]]
Parameters
INTERFACE-ID
(Optional) Specifies the interface to be display.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the
comma.
-
(Optional) Specifies a range of interfaces. No spaces before and
after the hyphen.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If the interface is not specified, all existing interfaces will be displayed.
Example
This example shows how to display the MAC address learning status on all physical ports 1 to 3.
Switch# show mac-address-table learning interface Ethernet 1/0/1-3
Port State
------------------------ --------
eth1/0/1 Enabled
eth1/0/2 Enabled
eth1/0/3 Enabled