User Manual

DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
28
7. Cable Diagnostics Commands
7-1 test cable-diagnostics
This command is used to start the cable diagnostics to test the status and length of copper cables.
test cable-diagnostics interface INTERFACE-ID
Parameters
interface INTERFACE-ID
Specifies the interface ID. The acceptable interface will
be a physical port.
Default
None.
Command Mode
EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
The command is available for physical port configuration. Cable Diagnostics can help users to detect
whether the copper Ethernet port has connectivity problems. Use the test cable-diagnostics
command to start the test.
Example
This example shows how to start the cable diagnostics to test the status and length of copper cables.
Switch# test cable-diagnostics interface Ethernet 1/0/1-2
Switch#
When running cable diagnostic on 10Mbps or 100Mbps speed, the port which is diagnosed will link
down and stop responding until the cable diagnostic is completed.
7-2 show cable-diagnostics
This command is used to display the test results for the cable diagnostics.
show cable-diagnostics [interface INTERFACE-ID ]
Parameters
interface INTERFACE-ID
Specifies the interface’s ID. The acceptable interface
will be a physical port.
Default