User Manual

DIS-200G Series Gigabit Ethernet Switch CLI Reference Guide
112
vlan VLAN-ID
(Optional) Specifies the VLAN interface. If no interface is specified,
MLD group information about all interfaces will be displayed.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display MLD group information by command.
Example
This example shows how to display MLD snooping group information.
Switch# show ipv6 mld snooping groups
MLD Snooping Connected Group Membership:
VLAN ID Group address Source address FM Exp(sec) Interface
------- ----------------- --------------------- -- -------- ---------
1 ff09::2 2015:2016::2017:2018 IN 260 eth1/0/1
1 ff09::c * EX 200 eth1/0/2
1 ff09::fb * IN 245 eth1/0/3
Total Groups : 3, Total SSM entries : 3
Switch#
23-7 show ipv6 mld snooping static-group
This command is used to display MLD snooping static group information on the Switch.
show ipv6 mld snooping static-group [ GROUP-ADDRESS | vlan VLAN-ID ]
Parameters
GROUP-ADDRESS
Specifies the group IPv6 address to be displayed.
vlan VLAN-ID
Specifies the VLAN ID to be displayed.
Default
None.
Command Mode