User Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration
- Web-based Configuration Utility
- Internet Connection Setup Wizard
- Manual Configuration
- Wireless Settings
- Network Settings
- Virtual Server
- Port Forwarding
- Application Rules
- QoS Engine
- Network Filters
- Access Control
- Website Filters
- Inbound Filters
- Firewall Settings
- Routing
- Advanced Wireless Settings
- Advanced Network Settings
- IPv6
- Administrator Settings
- Time Settings
- SysLog
- E-mail Settings
- System Settings
- Update Firmware
- DDNS
- System Check
- Schedules
- Device Information
- Log
- Stats
- Internet Sessions
- Routing Table
- Wireless
- IPv6
- Support
- Web-based Configuration Utility
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
- Contacting Technical Support
- Warranty
- Registration
33D-Link DIR-601 User Manual
Section 3 - Configuration
Check this box to enable the DHCP server on your
router. Uncheck to disable this function.
Enter the starting and ending IP addresses for
the DHCP server’s IP assignment.
Note: If you statically (manually) assign IP
addresses to your computers or devices, make
sure the IP addresses are outside of this range
or you may have an IP conflict.
The length of time for the IP address lease. Enter the Lease time in minutes.
Enable this function to ensure compatibility with some DHCP clients.
Enable DHCP
Server:
DHCP IP Address
Range:
Lease Time:
Always
Broadcast:
DHCP Server Settings
DHCP stands for Dynamic Host Control Protocol. The DIR-601 has a built-in DHCP server. The DHCP Server will
automatically assign an IP address to the computers on the LAN/private network. Be sure to set your computers to be
DHCP clients by setting their TCP/IP settings to “Obtain an IP Address Automatically.” When you turn your computers
on, they will automatically load the proper TCP/IP settings provided by the DIR-601. The DHCP Server will automatically
allocate an unused IP address from the IP address pool to the requesting computer. You must specify the starting and
ending address of the IP address pool.