User's Manual

DIR-430 RangeBooster G Wireless Router User’s Guide Version : 1.0ȱ
Factory Defaults
This option is useful in a situation when, you are unable to revert back the
configuration changes, or if you find the configuration saved onto the Gateway is
not good to be used.
As shown in below, to set the factory defaults click on the Tools item on the top
panel, and click on Factory Defaults on the left hand menu. You will be asked to
respond to a question on whether to restore the factory defaults. Clicking on Yes
button restores the factory default settings onto the Gateway.
ȱ
The entire manual configuration done by you earlier will be erased when factory
defaults are set including the user’s password.
Reboot
To reboot the Gateway for any reason, click on Tools on the top panel, and click
on Reboot on the left hand menu. You will be asked for confirmation of the
reboot with Yes or No buttons.
Press Yes button to reboot the box. Though there is a physical reset button on
the Gateway, rebooting the box using HTML configuration is lot easier.
It is recommended to use this operation after firmware upgrade. This operation is
specifically useful when the Gateway is not easily reachable physically.
Press No button if you do not want to reboot the box.
Pageȱ85ȱofȱ103ȱ