User Manual Part 1

26D-Link DIR-330 User Manual
Section 3 - Configuration
IPSec Settings
Check this box to enable IPSec.
Enter a name for your VPN.
Select Tunnel.
Select Site to Site for LAN-to-LAN configuration
and enter the destination gateway IP address
in the box.
For LAN-to-LAN configuration, enter the
destination Subnet and Mask.
Enter the pre-shared key. The VPN Servers
Endpoint from both ends must use the same
key.
Cipher #1-4 - Select 3DES or AES.
Hash #1-4 - Select SHA1 or MD5.
Select PFS if both ends are supported.
Cipher #1-4 - Select 3DES or AES.
Hash #1-4 - Select SHA1 or MD5.
Enable:
Name:
Encapsulation:
Remote IP:
Remote Local
LAN Net/ Mask:
Authentication:
Phase 1-
IKE Proposal List:
Phase 2:
IKE Proposal List: