User manual

47D-Link DIR-685 User Manual
Section 3 - Configuration
Select Static PPPoE if your ISP assigned you the IP address, subnet
mask, and gateway addresses. In most cases, select Dynamic
PPPoE.
Enter your PPPoE user name.
Enter your PPPoE password and then retype the password in the
Conrm Password box.
Enter the ISP Service Name (optional).
Enter the IP address (Static PPPoE only).
The default MAC Address is set to the WAN/Internet port’s
physical interface MAC address on the Broadband Router. It is not
recommended that you change the default MAC address unless
required by your ISP. You can use the Clone MAC Address button to
replace the WAN/Internet port’s MAC address with the MAC address
of your Ethernet card.
Click the Receive DNS from ISP radio button to automatically obtain
the IP addresses of the DNS Servers for your Internet connection
from your ISP. Click the Enter DNS Manually radio button to
enter the DNS IP addresses manually. If choosing the manual
option, enter the IP addresses of the Primary and Secondary DNS
servers supplied by your ISP (Internet Service Provider) in the DNS
Addresses textbox.
Address Mode:
User Name:
Password:
Service Name:
IP Address:
MAC Address:
DNS Address:
Manual Internet Configuration
Russia PPPoE (Dual Access)
If you are in Russia and your ISP uses a PPPoE connection, choose Russia PPPoE (Dual Access) from the drop-
down menu. Your ISP will provide you with a username and password. Your ISP will provide you with a username
and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your
computer. The software is no longer needed and will not work through a router.