User manual
36D-Link DIR-615 User Manual
Section 3 - Conguration
Select one of the following:
802.11n Only - Select only if all of your wireless clients are 802.11n.
802.11 Mixed(g/b) - Select if you are using both 802.11b and 802.11g wireless clients.
802.11 Mixed(n/g/b) - Select if you are using a mix of 802.11n, 11g, and 11b wireless clients.
Select the Channel Width:
20MHz - Select if you are not using any 802.11n wireless clients. This is the default setting.
20/40MHz(Auto) - Select if you are using both 802.11n and non-802.11n wireless devices.
Check this box to reduce the guard interval time therefore increasing the data capacity. However, it’s less reliable and may
create higher data loss.
This section allows you to congure the MAC address of a computer, and allow or deny its access to wireless.
Use the drop-down list to select an SSID that has been congured in Wireless Network Name Setup.
Use the Congure Wireless MAC Filter Rules below drop-down list to select an universal MAC lter rule for the MAC
addresses listed in the elds below.
Enter the MAC address for the rule. The format should be xx:xx:xx:xx:xx:xx.
Wireless Mode:
Bandwidth:
Short Guard
Interval:
Wireless Mac
Filter:
SSID:
Wireless MAC
Filter Rule:
MAC Address: