User manual

52D-Link DIR-506L User Manual
Section 3 - Conguration
Select Enable to turn on routing and auto-select the RIP
version, or select RIPv1 or RIPv2.
Enter the IP address of packets that will take this route.
Enter the netmask of the route, please note that the octets
must match your destination IP address.
Enter your next hop gateway to be taken if this route is
used.
Enter a number to represent the hop value of this route.
Check to enable this route or leave unchecked to ignore it.
RIP:
Destination IP:
Subnet Mask:
Gateway:
Hop:
Enable:
Routing
The Routing option is an advanced method of customizing specic routes of data through your network. After making your
changes, click the Save Settings button.