User manual
45D-Link DIR-506L User Manual
Section 3 - Conguration
This will allow you to open a single port. If you would like to open a range of ports, refer to “Application Rules” on page 46. After
making your changes, click the Save Settings button.
Enter a name for the rule or select an application from
the drop-down menu and click << to automatically ll
in the rule with the default settings for that application.
Enter the IP address of the computer on your local
network that you want to allow the incoming service to.
If your computer is receiving an IP address automatically
from the router (DHCP), your computer will be listed in
the Computer Name drop-down menu. Select your
computer and click the << button to automatically ll in
the IP address.
Enter the port that you want to open next to Private
Port and Public Port. The private and public ports are
usually the same. The public port is the port seen from
the Internet side, and the private port is the port being
used by the application on the computer within your
local network.
Select TCP, UDP, or Both from the drop-down menu.
Name:
IP Address:
Private Port/
Public Port:
Trac Type:
Advanced
Virtual Server