User manual
27D-Link DIR-506L User Manual
Section 3 - Conguration
Select Static IP if your ISP assigned you an IP address,
subnet mask, gateway, and DNS server address. In most
cases, select Dynamic IP.
Enter the IP address (for static PPPoE only).
Enter your PPPoE user name.
Enter your PPPoE password and then retype the password
in the next box.
Enter the ISP service name (optional).
Select either Always-on, On-Demand, or Manual.
Enter a maximum idle time during which the Internet
connection is maintained during inactivity. To disable this
feature, set the Reconnect Mode to Always on.
Enter the primary and secondary DNS server addresses
(Static PPPoE only).
If you experience connection issues, you may need to
change the MTU setting for optimal performance with
your specic ISP. 1492 is the default MTU.
If your ISP requires you to enter a MAC address, ll it in
here. You can click the Clone MAC button to enter your
current computer’s MAC address.
Address Mode:
IP Address:
User Name:
Password:
Service Name:
Reconnect
Mode:
Maximum Idle
Time:
Primary/
Secondary DNS
Server:
MTU:
MAC Address:
If you selected PPPoE, you will see the following settings. Your ISP will provide you with a username and password. This option
is typically used for DSL services. Make sure to remove your PPPoE software from your computer. The software is no longer
needed and will not work through a router.