User manual

135D-Link DIR-505L User Manual
Section 3 - Conguration
System
Save to Local
Hard Drive:
Upload from
Local Hard
Drive:
Restore to
Factory Default:
Reboot the
Device:
Remove
Language Pack
Use this option to save the current access point
conguration settings to a le on the hard disk of the
computer you are using. Click the Save button. You will
then see a le dialog where you can select a location and
le name for the settings.
Use this option to load previously saved access point
conguration settings. Click Browse to nd a previously
saved conguration le. Then, click the Upload Settings
button to transfer those settings to the access point.
This option will restore all conguration settings back
to the settings that were in eect at the time the access
point was shipped from the factory. Any settings that
have not been saved will be lost, including any rules that
you have created. If you want to save the current access
point conguration settings, use the Save button above.
Note: Restoring the factory default settings will not reset the
Wi-Fi Protected Status to “Not Congured.”
Click to reboot the access point.
Click to remove any installed language packs.