Owner's manual

49D-Link DIR-455 User Manual
Section 3 - Configuration
RIP SETTING
Select this box to enable routing.
Ripv1: Protocol in which the IP address is
routed through the internet.
RIPv2: Enhanced version of RIPv1 with added
features such as Authentication, Routing
Domain, Next Hop Forwarding, and Subnet-
mask Exchange.
ROUTING RULES
Identies the rule.
Enter in the IP of the specied network that you
want to access using the static route.
Enter in the subnet mask to be used for the
specied net work.
Enter in the gateway IP address to the specied network.
Enter in the amount of hops it will take to reach the specied network.
Note: In a transmission path, each link is terminated at a network device such as a router or gateway. The
number of hops equals the number of routers or gateways that data must pass through before reaching the
destination.
Select this box to enable the rule.
Routing
RIP:
ID:
Destination:
Subnet Mask:
Gateway:
Hop:
Enable:
The Routing page allows you to specify custom routes that determine how data is moved around your network.