Systems Network Router User Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration
- Web-based Configuration Utility
- Internet Connection Setup Wizard (3G Mode)
- Manual Configuration (3G Mode)
- Internet Connection Setup Wizard (WAN Mode)
- Manual Configuration (WAN Mode)
- Wireless Settings
- Network Settings
- Virtual Server
- Port Forwarding
- Application Rules
- QoS Engine
- Network Filters
- Website Filters
- Firewall Settings
- Advanced Wireless Settings
- Wi-Fi Protected Setup
- Advanced Network Settings
- Administrator Settings
- Time Settings
- E-mail Settings
- System Settings
- Update Firmware
- DDNS
- System Check
- Schedules
- Device Information
- Logs
- Statistics
- Internet Sessions
- Wireless
- Support
- Web-based Configuration Utility
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
- Contacting Technical Support
- Warranty
- Registration
30D-Link DIR-412 User Manual
Section 3 - Conguration
Select Static IP if your ISP assigned you the IP address,
subnet mask, gateway, and DNS server addresses. In
most cases, select Dynamic IP.
Enter the L2TP IP address supplied by your ISP (Static
IP only).
Enter the Subnet Mask supplied by your ISP (Static
L2TP only).
Enter the Gateway IP address provided by your ISP
(Static L2TP only).
Enter the Server IP address provided by your ISP
(optional).
Enter your L2TP user name.
Enter your L2TP password and then retype the
password in the next box.
Select either Always-on, On-Demand, or Manual.
Address Mode:
L2TP IP Address:
L2TP Subnet
Mask:
L2TP Gateway
IP Address:
L2TP Server IP
Address:
User Name:
Password:
Reconnect
Mode:
Choose L2TP (Username/Password) from the My Internet Connection is drop-down menu if your ISP uses an L2TP connection.
Your ISP will provide you with a username and password. This option is typically used for DSL services.
Manual Conguration (WAN Mode)
L2TP (Username/Password)