Systems Network Router User Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration
- Web-based Configuration Utility
- Internet Connection Setup Wizard (3G Mode)
- Manual Configuration (3G Mode)
- Internet Connection Setup Wizard (WAN Mode)
- Manual Configuration (WAN Mode)
- Wireless Settings
- Network Settings
- Virtual Server
- Port Forwarding
- Application Rules
- QoS Engine
- Network Filters
- Website Filters
- Firewall Settings
- Advanced Wireless Settings
- Wi-Fi Protected Setup
- Advanced Network Settings
- Administrator Settings
- Time Settings
- E-mail Settings
- System Settings
- Update Firmware
- DDNS
- System Check
- Schedules
- Device Information
- Logs
- Statistics
- Internet Sessions
- Wireless
- Support
- Web-based Configuration Utility
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
- Contacting Technical Support
- Warranty
- Registration
108D-Link DIR-412 User Manual
Appendix E - Warranty
Industry Canada Statement
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may cause undesired operation of the device
This device has been designed to operate with an antenna having a maximum gain of 2dBi.
Antenna having a higher gain is strictly prohibited per regulations of Industry Canada. The required antenna
impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the EIRP is not
more than required for successful communication.
IMPORTANT NOTE:
IC Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should
be installed and operated with minimum distance 20cm between the radiator and your body.
The availability of some specic channels and/or operational frequency bands are country dependent and are rmware programmed at the factory
to match the intended destination. The rmware setting is not accessible by the end user.
For detailed warranty information applicable to products purchased outside the United States, please contact the corresponding local D-Link
oce.