Specifications

68D-Link DIR-330 User Manual
Section 4 - Security
Configure WEP
It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to
the added overhead.
1. Log into the web-based configuration by opening a
web browser and entering the IP address of the router
(192.168.0.1). Click on Setup and then click Wireless
Settings on the left side.
2. Click the Manual Wireless Connection Setup button.
3. Next to Security Mode, select Enable WEP.
4. Next to Authentication, select Shared Key or Open.
5. Next to WEP Encryption, select the level of ecryption (64
or 128-bit).
6. Next to Default WEP Key, select the key to modify. You
may enter up to 4 different keys.
7. Next to WEP Key, enter a WEP key you create. Make sure
you enter this key exactly on all your wireless devices.
8. Click Save Settings to save your settings. If you are configuring the router with a wireless adapter, you will lose
connectivity until you enable WEP on your adapter and enter the same WEP key as you did on the router.