Specifications

35D-Link DIR-330 User Manual

Section 3 - Conﬁguration

PPTP/L2TP Settings

Check this box to enable.

Enter a name for your VPN.

Select PPTP, L2TP, or L2TP over IPsec.

Enter the VPN Server IP address which is the

LAN IP of the router. (i.e. 192.168.0.1).

Assign a range of IP addresses. The assigned IP

range should be on the same IP network but not

the in the same range as your DHCP IP range.

For example, if your network is 192.168.0.xxx

and you set the DHCP range to 192.168.0.100-

200, the remote IP range cannot be within

192.168.0.100-200.

Select the desired authentication protocol (PAP/

CHAP/MS-CHAP v2).

Select the level of encryption (None/40-bit/128-

bit).

Select a user group from the drop-down menu.

You can create user groups in the Advanced

> User Group section.

Enable Setting:

Name:

Connection Type:

VPN Server IP:

Remote IP Range:

Authentication

Protocol:

MPPE Encryption

Mode:

Authentication

Database:

PPTP uses TCP port 1723 for its control connection and uses GRE (IP protocol 47) for the PPP data. PPTP supports

data encryption by used MPPE. L2TP uses UDP protocol to transport the PPP data. This is often encapsulated in IPsec

encryption instead of MPPE.