Specifications

23D-Link DIR-330 User Manual
Section 3 - Configuration
Select PPPoE (Username/Password) from the drop-down
menu.
In most cases, select Dynamic. Select Static if your ISP
assigned you the IP address, subnet mask, gateway, and DNS
server addresses.
Enter your PPPoE user name.
Enter your PPPoE password and then retype the password in
the next box.
Enter the ISP Service Name (optional).
Enter the IP address (Static PPPoE only).
The default MAC Address is set to the Internet port’s physical
interface MAC address on the Broadband Router. It is not
recommended that you change the default MAC address unless
required by your ISP. You can use the Clone MAC Address
button to replace the Internet port’s MAC address with the MAC
address of your Ethernet card.
Enter a maximum idle time during which the Internet connection
is maintained during inactivity. To disable this feature, enable
Always-on (Connect Mode option below).
You may need to change the MTU (Maximum Transmission
Unit) for optimal performance with your specific ISP. 1492 is the default MTU.
My Internet
Connection:
Address Mode:
User Name:
Password:
Service Name:
IP Address:
MAC Address:
Maximum Idle Time:
MTU:
Internet Setup
Russian PPPoE
Choose Russian PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will
provide you with a username and password. This option is typically used for DSL services. Make sure to remove your
PPPoE software from your computer. The software is no longer needed and will not work through a router.