Operation Manual

20D-Link DIR-100 User Manual
Section 3 - Configuration
Select Dynamic (most common) or Static. Select
Static if your ISP assigned you the IP address, subnet
mask, gateway, and DNS server addresses.
Enter your PPPoE user name.
Enter your PPPoE password and then retype the
password in the next box.
Enter the ISP Service Name (optional).
Enter the IP address (Static PPPoE only).
Enter the Primary and Secondary DNS Server Addresses
(Static PPPoE only).
Enter a maximum idle time during which the Internet
connection is maintained during inactivity. To
disable this feature, enable Auto-reconnect.
Maximum Transmission Unit - you may need to change
the MTU for optimal performance with your specific ISP.
1492 is the default MTU.
Select either Always-on, Manual, or Connect-on demand.
PPPoE:
User Name:
Password:
Service Name:
IP Address:
Primary DNS
Addresses:
Maximum Idle
Time:
MTU:
Connection Mode
Select:
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a username
and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your computer. The
software is no longer needed and will not work through a router.
Internet Setup
PPPoE (DSL)