User`s guide

DSL-G624M Wireless 108G MIMO ADSL2/2+ Router User’s Guide
37
The parameters described below are used to set up filter rules.
Parameter Description
Source IP
For an Outbound Filter, this is the IP address or IP addresses on your LAN for which
you are creating the filter rule. For an Inbound Filter, this is the IP address or IP
addresses for which you are creating the filter rule. You can opt to indicate a Mask
Range, a Single IP, an IP Range or Any IP from the pull-down menu. Choosing Any
IP will apply the rule to all WAN or all LAN IP addresses depending on which type of
rule (Inbound or Outbound) is being configured.
Destination IP
Where the Destination IP address resides also depends on if you are configuring an
Inbound or Outbound filter rule. You can opt to indicate a Mask Range, a Single IP,
an IP Range or Any IP from the pull-down menu.
Port Range
This is the range of TCP/UDP for the current Filter rule. Enter the range of TCP/UDP
ports to be filtered.
Protocol Type
Select the transport protocol (TCP, UDP or Both) that will be used for the filter rule.
Click the Apply button to put the new rule into effect. Any filter rule configured in the menu will appear in the Filters
List with the new settings. The Router must save the new settings and reboot before the new rules are applied.