Remote Access Router User's Guide

DI-1162 Remote Access Router
Configuration and Management 85
•
Range – this is the range of contiguous local addresses above (and
including) the base
Local IP
.
• State – this toggles the enable, disable, for this NAT entry.
Dynamic NAPT
This screen (below) is how the
NAT IP Pool
appears, if
Dynamic
NATPT
was chosen for the
Translation Mode
parameter. Each entry,
in this configuration, can be used to map a single global address and
multiple, contiguous local addresses to each other.
All of the parameters are the same as in
Dynamic NAT
, except the
Global IP
is a solitary, global address.
• Global IP – this is a single, globally unique IP Address of the
global interface (the interface to which it is assigned, in this case,
one of the WAN interfaces) that is valid on the Internet.