Remote Access Router User's Guide

DI-1162 Remote Access Router
56 Configuration and Management
Dynamic - taken from the
Dial In IP pool
, or
None - the remote user supplies his own IP Address.
State – enables/disables this User Profile.
Remote Network Profile
The Remote Network Profile is used to configure the router for
WAN connections to other networks. In practice, the DI-1162 will
either dial-out to or receive incoming calls from another router, the
‘gateway’ to the other network.
•
Remote Name – Name for the remote network that the DI-1162 is
being set up to connect with.
•
Direction – dial-[In], dial-[Out], or [Both]. This field defines
whether the router on the other network will dial-[In] to the DI-
1162 to establish a connection, the DI-1162 will dial-[Out] to the
other network, or a connection can be established [Both] ways.
When this is set to In, the DI-1162 will only establish a connection
with the other network by receiving calls on the WAN port
specified in the
Interface
field below. Also, the incoming calls
will be subject to the
Name
,
Password
and
Rem CLID
fields in the
Incoming section below.