Remote Access Router User's Guide

DI-1162 Remote Access Router
20 Installation
•
SLIP – asynchronous mode used for
modems.
• Async PPP - asynchronous mode used
for modems.
• HDLC – synchronous mode used for
CSU/DSU’s or synchronous modems
using a leased line.
•
Sync PPP - synchronous mode used for
CSU/DSU’s or synchronous modems
using a leased line.
♦ Position the cursor over the State item and press <space bar>.
The State will change from Disable to Enable.
♦ Other Items in this screen also need to be configured such as the
Phone Number and Baud Rate. Please refer to the manual for
the device being connected to the WAN port for the proper
settings. For more information regarding these settings, please
refer to the appropriate section in the
Configuration and
Management
chapter of this User Guide.
♦ Position the cursor on the Save option at the bottom of the
screen and press <Enter> to save the new setting.
♦ Choose Exit in the sub-menus to return to the Main Menu.
2. Enable IP Networking
♦ Choose Network Configuration, IP
Configuration.
♦ Position the cursor over the last item IP Networking
and press <space bar> to Enable it.
♦ Position the cursor on the Save option at the bottom of the
screen and press <Enter> to save the new setting.