User manual
49D-Link DHP-1320 User Manual
Section 3 - Conguration
The Virtual Server window allows you to open a single port. If you would like to open a range of ports, refer to the next page.
Check the box on the left side to enable the Virtual
Server rule.
Enter a name for the rule or select an application from
the drop-down menu. Select an application and click
<< to populate the elds.
Enter the IP address of the computer on your local
network that you want to allow the incoming service to.
If your computer is receiving an IP address automatically
from the router (DHCP), you computer will be listed in
the Computer Name drop-down menu. Select your
computer and click <<.
Enter the port that you want to open next to Public
Port and Private Port. The public and private ports are
usually the same. The public port is the port seen from
the Internet side, and the private port is the port being
used by the application on the computer within your
local network.
Select TCP, UDP, Both or other from the Protocol drop-
down menu.
Use the drop-down menu to schedule the time that the Virtual Server Rule will be enabled. The schedule may be set to Always,
which will allow the particular service to always be enabled. You can create your own times in the Tools > Schedules section.
Select Allow All (most common) or a created Inbound lter. You may create your own inbound lters in the Advanced > Inbound
Filter page.
Enable
Checkbox:
Name:
IP Address:
Public Port/
Private Port:
Trac Type:
Schedule
Drop-Down
Menu:
Inbound Filter:
Click the Save Settings button to save any changes made.