User manual

D-Link Corporation confidential
12
Feature
Detailed Description
 IPv6 in IPv4 Tunnel Mode
IPv6 in IPv4 tunneling is the encapsulation of IPv6 packets in IPv4
packets so that IPv6 packets can be sent over an IPv4 infrastructure.
 6to4 Mode
6to4 is an IPv6 address assignment and automatic tunneling technology
that used to provide unicast IPv6 connectivity between IPv6 sites and
hosts across the IPv4 Internet.
 Enable Autoconfiguration
These two values (from and to) define a range of IPv6 addresses that the
DHCPv6 Server uses when assigning addresses to computers and devices
on your Local Area Network. Any addresses that are outside of this range
are not managed by the DHCPv6 Server; these could, therefore, be used
for manually configured devices or devices that cannot use DHCPv6 to
obtain network address details automatically.
When you selected Stateful (DHCPv6), the following options are
displayed.
The computers (and other devices) connected to your LAN also need to
have their TCP/IP configuration set to “DHCPv6” or “Obtain an IPv6
address automatically”.
2.2.3.13
Guest Zone

Guest Zone provides a separate network zone for guest to access internet.
2.2.4 Tools
Feature
Detailed Description
2.2.4.1
Admin
 The Admin option is used to set a password for access to the Web-based
management and enable Remote Management that allows admins to
manage the router from anywhere on the Internet.
 Admin Password
Enter a password for the user “admin”, who will have full access to the
Web-based management interface.
 User Password
Enter a password for the user “user”, who will have read-only access to
the Web-based management interface.
 System Name
The name of the router can be changed here.
 Administration
Enabling Remote Management allows you to manage the router from
anywhere on the Internet. Disabling Remote Management allows you to
manage the router only from computers on your LAN.
2.2.4.2
Time
 The Time Configuration option allows admins to configure, update, and
maintain the correct time on the router’s internal system clock.
 Time Configuration
From this section admins can set the time zone that users are in and
daylight saving can also be configured to automatically adjust the time
when needed.
 Automatic Time Configuration
This section allows admins to setup the time configuration through NTP.
 Set The Date and Time Manually