Specifications

xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
2
Features
The list of features and protocols below highlights the significant features supported by the xStack
®
DGS-3600 Series.
Physical Stackingup to 12 devices, with a bandwidth up to 40G
Virtual Stacking
IEEE 802.3ad Link Aggregation Control Protocol
IEEE 802.1X Port-based and MAC-based Access Control
IEEE 802.1Q VLAN
IEEE 802.1D Spanning Tree, IEEE 802.1w Rapid Spanning Tree, and IEEE 802.1s Multiple Spanning Tree
IEEE 802.3x flow control in full duplex mode
IEEE 802.1p Priority Queues
IEEE 802.3u 100BASE-TX
Access Control List (ACL)
Single IP Management
Access Authentication Control (AAC) utilizing TACACS, XTACACS, and TACACS+
Internal Flash Drive for saving configurations and firmware
Simple Network Time Protocol (SNTP)
MAC Notification
VLAN Groupmaximum 4K static VLAN groups, maximum 255 dynamic VLAN groups
Configurable VLAN ID1 to 4094
Double VLAN
Q-in-Q—translation VLAN ASIC 768 entries
Guest VLAN
IGMP Snooping Multicast VLAN (ISM VLAN), including tag/untagged member and source support and configurable
multicast VLAN prioritythere is no limit on the total multicast address number per ISM VLAN entry
MAC-based VLANASIC 1024 VLAN MAC entries
VLAN PVID auto assign
VLAN trunking
Subnet VLAN
Super VLAN
BPDU Protection
ITU-T G.8032 Ethernet Ring Protection Switching (ERPS)support for 2 rings
System and Port Utilization
8-level System Log
Port-based enable and disable
Address table: up to 16K MAC addresses per device
Packet buffer of up to 2M bytes
Port Trunking with flexible load distribution and fail-over function
Link Aggregation Control Protocol (LACP) supports load-balancing with multicast traffic
IGMP Snooping
MLD Snooping
SNMP
Telnet Client
TFTP Client
RMONv1/v2
CPU Monitoring
Remote Switched Port Analyzer (RSPAN)
Link Layer Discovery Protocol (LLDP)
Layer 2 Protocol tunneling
Secure Sockets Layer (SSL) v3 and Secure Shell (SSH) v2
Port Security