Installation guide

xStack
®
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
28
CAUTION: Installing systems in a rack without the front and side stabilizers installed could cause the
rack to tip over, potentially resulting in bodily injury under certain circumstances. Therefore, always
install the stabilizers before installing components in the rack. After installing components in a rack, do
not pull more than one component out of the rack on its slide assemblies at one time. The weight of
more than one extended component could cause the rack to tip over and may result in injury.
DPS-800
The DPS-800 is a st andard-size rack m ount (1 standard unit i n height) designed t o h old u p to t wo DPS-200 redundant power
supplies.
Figure 2- 20. Installing the DPS-200 in the DPS-800
The RPS can be mounted in a standard 19" rack. Use the following diagram to guide you.
Figure 2- 21. Installing the DPS-800 in an Equipment Rack