Installation guide

xStack

DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch

Installing SFP Ports

The Switch is equipped with SFP (Small Form Factor Portable) ports, which are to be used with fiber-optical transceiver cabling

in order t o uplink va rious ot her networking devices for a gi gabit l ink that may span g reat distances. T hese SF P ports s upport

full-duplex transmissions, h ave auto-negotiation and can b e used w ith D EM-310GT ( 1000BASE-LX), D EM-311GT

(1000BASE-SX), D EM-312GT2 (1000BASE-SX), DEM-314GT ( 1000BASE-LH) and DEM-315GT (1 000BASE-ZX)

transceivers. See the figure below for installing the SFP ports in the Switch. In addition, DEM-210 (Single Mode, 100BASE-FX)

and DEM-211* (Multi Mode, 100BASE-FX) SFP transceivers are supp orted. WDM transceivers supported in clude DEM-220T

(Singlemode, TX-1550/RX-1310nm), DEM-220R (Singlemode, TX-1310/RX-1550 nm), Singlemode, DEM-330T (TX-1550/RX-

1310nm), DEM-330R (TX-1310/RX-1550nm), DEM-331T (TX-1550/RX-1310nm), and DEM-331R (TX1310/RX-1550).

Figure 2- 14. Inserting the fiber-optic transceivers into the DGS-3200-10

Figure 2- 15. Inserting the fiber-optic transceivers into the DGS-3200-16

Figure 2- 16. Inserting the fiber-optic transceivers into the DGS-3200-24

NOTE: *The fiber-optic transceiver module DEM-211 may fail to link when inserted into

the SFP ports if the two combo copper ports are both in linking status. The solution to this

limitation is to remove the combo copper cable before using this module. Only module

DEM-211 has this limitation.