Specifications

DGS-3048 Layer 2 Switch CLI Reference Manual
74
STP Status : Enabled
STP Version : RSTP
Max Age : 20
Hello Time : 2
Forward Delay : 15
Max Age : 20
TX Hold Count : 3
Forwarding BPDU : Enabled
DGS3048#
Status 3 : STP enabled for MSTP
DGS3048#show stp
Command: show stp
STP Status : Enabled
STP Version : MSTP
Max Age : 20
Forward Delay : 15
Max Age : 20
TX Hold Count : 3
Forwarding BPDU : Enabled
DGS3048#
show stp ports
Purpose Used to display the Switch’s current instance_id configuration.
Syntax
show stp ports <portlist>
Description This command displays the STP Instance Settings and STP
Instance Operational Status currently implemented on the Switch.
Parameters
<portlist> − Specifies a range of ports to be viewed. The port list
is specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the
highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end
of the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2,
port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3
and switch 2, port 4 − in numerical order.
Restrictions None.
Example usage:
To show stp ports 1 through 9 on switch one:
DGS3048#show stp ports 1-9
Command: show stp ports 1-9