Specifications

DGS-3048 Layer 2 Switch CLI Reference Manual

To display the current status of the syslog function:

DGS3048#show syslog

Command: show syslog

Syslog Global State: Enabled

DGS3048#

create syslog host

Purpose Used to create a new syslog host.

Syntax

create syslog host <index 1-4> ipaddress <ipaddr> {severity

<udp_port_number>

Description

The create syslog host command is used to create a new syslog

host.

Parameters

all − Specifies that the command will be applied to all hosts.

<index 1-4> − Specifies that the command will be applied to an index

of hosts. There are four available indexes, numbered 1 through 4.

ipaddress <ipaddr> − Specifies the IP address of the remote host

where syslog messages will be sent.

severity − Severity level indicator. These are described in the

following:

Bold font indicates that the corresponding severity level is currently

supported on the Switch.

Numerical Severity

Code

0 Emergency: system is unusable

1 Alert: action must be taken immediately

2 Critical: critical conditions

3 Error: error conditions

4 Warning: warning conditions

5 Notice: normal but significant condition

6 Informational: informational messages

7 Debug: debug-level messages

informational − Specifies that informational messages will be sent to

the remote host. This corresponds to number 6 from the list above.

warning − Specifies that warning messages will be sent to the

remote host. This corresponds to number 4 from the list above.

all − Specifies that all of the currently supported syslog messages

that are generated by the Switch will be sent to the remote host.

facility − Some of the operating system daemons and processes

have been assigned Facility values. Processes and daemons that

have not been explicitly assigned a Facility may use any of the "local

use" facilities or they may use the "user-level" Facility. Those

Facilities that have been designated are shown in the following:

Bold font indicates the facility values that the Switch currently

supports.