Specifications

DGS-3048 Layer 2 Switch CLI Reference Manual
51
7
DOWNLOAD/UPLOAD COMMANDS
The download/upload commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
download [firmware <ipaddr> <path_filename 64> | boot <ipaddr>
<path_filename 64> | configuration <ipaddr> <path_filename 64>
{startup | running}]
upload configuration <ipaddr> <path_filename 64> {startup | running}
Each command is listed, in detail, in the following sections.
download
Purpose Used to download and install new firmware or a switch configuration
file from a TFTP server.
Syntax
download [firmware [firmware <ipaddr> <path_filename 64> |
boot <ipaddr> <path_filename 64> |
configuration <ipaddr> <path_filename 64> {startup | running}]
Description This command is used to download a new firmware or a switch
configuration file from a TFTP server.
Parameters
firmware − Download and install new firmware on the Switch from a
TFTP server.
configuration − Download a switch configuration file from a TFTP
server.
<ipaddr> − The IP address of the TFTP server.
<path_filename> − The DOS path and filename of the firmware or
switch configuration file on the TFTP server. For example,
C:\3048.had.
increment − Allows the download of a partial switch configuration file.
This allows a file to be downloaded that will change only the Switch
parameters explicitly stated in the configuration file. All other switch
parameters will remain unchanged.
startup − Indicates the Startup Configuration file.
running − Indicates the Running Configuration file.
Restrictions The TFTP server must be on the same IP subnet as the Switch.
Only administrator-level users can issue this command.
Example usage: