Specifications

DGS-3048 Layer 2 Switch CLI Reference Manual
46
show trusted_host
Purpose Used to display a list of trusted hosts entered on the Switch using
the create trusted_host command above.
Syntax
show trusted_host {<ipaddr>}
Description This command is used to display a list of trusted hosts entered on
the Switch using the create trusted_host command above.
Parameters
<ipaddr> − The IP address of the trusted host.
Restrictions None.
Example Usage:
To display the list of trust hosts:
DGS3048#show trusted_host
Command: show trusted_host
Management Stations
IP Address
-----------------------
10.53.13.94
Total Entries: 1
DGS3048#
enable snmp traps
Purpose Used to enable SNMP trap support.
Syntax
enable snmp traps
Description
The enable snmp traps command is used to enable SNMP trap
support on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable SNMP trap support on the Switch:
DGS3048#enable snmp traps
Command: enable snmp traps
Success.
DGS3048#