Specifications

DGS-3048 Layer 2 Switch CLI Reference Manual
29
6
NETWORK MANAGEMENT (SNMP) COMMANDS
The network management commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
The DGS-3048 supports the Simple Network Management Protocol (SNMP) versions 1, 2c, and 3. The user may
specify which version of the SNMP to use to monitor and control the Switch. The three versions of SNMP vary in
the level of security provided between the management station and the network device. The following table lists
the security features of the three SNMP versions:
SNMP
Version
Authentication Method Description
v1 Community String
Community String is used for authentication − NoAuthNoPriv
v2c Community String
Community String is used for authentication − NoAuthNoPriv
v3 Username
Username is used for authentication − NoAuthNoPriv
v3 MD5 or SHA
Authentication is based on the HMAC-MD5 or HMAC-SHA algorithms
− AuthNoPriv
v3 MD5 DES or SHA DES
Authentication is based on the HMAC-MD5 or HMAC-SHA algorithms
− AuthPriv.
DES 32-bit encryption is added based on the CBC-DES (DES-32)
standard
Command Parameters
create snmp user <username 24> <groupname 30> [encrypted [by_password
auth [md5 <auth_password 1-32> | sha <auth_password 1-
32>] | by_key auth [md5 <auth_key 32 or 64>| sha<auth_key
40 or 72>]]]
delete snmp user <username 24>
show snmp user
create snmp view <view_name 32> <oid> view_type [included | excluded]
delete snmp view <view_name 30> [all | oid]
show snmp view {<view_name 30>}
create snmp community <community_string 20> view <view_name 30> [read_only |
read_write]
delete snmp community <community_string 20>
show snmp community {<community_string 20>}
config snmp engineID [Default | <snmp_engineID 10-64>]
show snmp engineID
create snmp group <groupname 30> [v1 | v2c | v3 [noauth_nopriv | auth_nopriv |
auth
p
riv
]{
notif
y
view <view name 30>
}]
{
read view