Specifications

DGS-3048 Layer 2 Switch CLI Reference Manual
27
show ports
Purpose Used to display the current configuration of a range of ports.
Syntax
show ports {<portlist>}
Description This command is used to display the current configuration of a range
of ports.
Parameters
<portlist> − Specifies a port or range of ports to be displayed.
Restrictions None.
Example usage:
To display the configuration of ports 1-5 on the Switch:
DGS3048#show ports 1-5
Command: show ports 1-5
Port Port Settings Connection Address
State Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
--- -------- --------------------- --------------------- --------
1 Enabled Auto/Enabled Link Down Enabled
2 Enabled Auto/Enabled Link Down Enabled
3 Enabled Auto/Enabled 1000M/Full?None Enabled
4 Enabled Auto/Enabled Link Down Enabled
5 Enabled Auto/Enabled Link Down Enabled
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
config ports description
Purpose Used to add a descrition to an interface or rages of interface
Syntax
<portlist> <string 1-64>
Description This command enables user to add a descrition to an interface or
rages of interfaces.
Parameters
<portlist> − Specifies a port or range of ports to be displayed.
<string 1-64> − description content
Restrictions None
Example usage:
To add a description to an interface:
DGS3048# config ports description
Command: config ports description
PORT_LIST specifies range of ports.
DGS3048#