Specifications

DGS-3048 Layer 2 Switch CLI Reference Manual

config ports

Purpose Used to configure the Switch’s Ethernet port settings.

Syntax

config ports [all | <portlist>] {speed [auto | 10_half | 10_full | 100_half

[enable | disable] | state [enable | disable]}

Description This command allows for the configuration of the Switch’s Ethernet ports.

Only the ports listed in the <portlist> will be affected.

Parameters

<portlist> − Specifies a range of ports to be configured.

all − Configure all ports on the Switch.

speed – Allows the user to set the speed of a port or range of ports, with

the addition of one of the following:

 auto − Enables auto-negotiation for the specified range of ports.

 [10 | 100 | 1000] − Configures the speed in Mbps for the specified

range of ports. The

 [half | full] − Configures the specified range of ports as either full-

or half-duplex.

[master | slave] – The master and slave parameters refer to connections

running a 1000BASE-T cable for connection between the Switch port and

other device capable of a gigabit connection. The master setting will allow

the port to advertise capabilities related to duplex, speed and physical

layer type. The master setting will also determine the master and slave

relationship between the two connected physical layers. This relationship

is necessary for establishing the timing control between the two physical

layers. The timing control is set on a master physical layer by a local

source. The slave setting uses loop timing, where the timing comes form

a data stream received from the master. If one connection is set for 1000

master, the other side of the connection must be set for 1000 slave. Any

other configuration will result in a link down status for both ports.

flow_control [enable | disable] – Enable or disable flow control for the

specified ports.

learning [enable | disable] − Enables or disables the MAC address

learning on the specified range of ports.

state [enable | disable] − Enables or disables the specified range of ports.

Restrictions Only administrator-level users can issue this command.

Example usage:

To configure the speed of ports 1-3 to be 10 Mbps, full duplex, learning and state enabled:

DGS3048#config ports 1-3 speed 10_full learning enable state enable

Command: config ports 1-3 speed 10_full learning enable state enable

Success.

DGS3048#