Specifications

DGS-3048 Layer 2 Switch CLI Reference Manual
20
reset
Purpose Used to reset the Switch to the factory default settings.
Syntax
reset
Description This command is used to restore the Switch’s configuration to the
default settings assigned from the factory.
Parameters
config − If the keyword ‘config’ is specified, all of the factory default
settings are restored on the Switch including the IP address, user
accounts, and the Switch history log. The Switch will not save or
reboot.
system − If the keyword ‘system’ is specified, all of the factory
default settings are restored on the Switch. The Switch will save and
reboot after the settings are changed to default. Rebooting will clear
all entries in the Forwarding Data Base.
If no parameter is specified, the Switch’s current IP address, user
accounts, and the Switch history log are not changed. All other
parameters are restored to the factory default settings. The Switch
will not save or reboot.
Restrictions Only administrator-level users can issue this command.
Example usage:
To restore all of the Switch’s parameters to their default values:
DGS3048# reset config
Command: reset config
Success.
DGS3048#
login
Purpose Used to log in a user to the Switch’s console.
Syntax
login
Description This command is used to initiate the login procedure. The user will be
prompted for his Username and Password.
Parameters None.
Restrictions None.
Example usage:
To initiate the login procedure:
DGS3048#login
Command: login
UserName: