Specifications

DGS-3048 Layer 2 Switch CLI Reference Manual
16
config serial_port
Purpose Used to configure the serial port.
Syntax
config serial_port {baud_rate [9600 | 19200 | 38400 | 115200]
auto_logout [never | 2_minutes | 5_minutes| 10_minutes |
15_minutes]}
Description
This command is used to configure the serial port’s baud rate and auto
logout settings.
Parameters
baud rate [9600 | 19200 | 38400 | 115200] − The serial bit rate that will be
used to communicate with the management host.
auto_logout - This parameter will allow the user to choose the time the
Switch’s serial port will be idle before automatically logging out. The user
may choose one of the following.
 never − No time limit on the length of time the console can be open
with no user input.
 2_minutes − The console will log out the current user if there is no
user input for 2 minutes.
 5_minutes − The console will log out the current user if there is no
user input for 5 minutes.
 10_minutes − The console will log out the current user if there is
no user input for 10 minutes.
 15_minutes − The console will log out the current user if there is
no user input for 15 minutes.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the baud rate:
DGS3048# config serial_port baud_rate 9600
Command: config serial_port baud_rate 9600
Success.
DGS3048#