Specifications

DGS-3048 Layer 2 Switch CLI Reference Manual
167
config arp_aging time
Purpose Used to configure the age-out timer for ARP table entries on the
Switch.
Syntax
config arp_aging time <value 1- 65535 >
Description This command sets the maximum amount of time, in minutes, that
an ARP entry can remain in the Switch’s ARP table, without being
accessed, before it is dropped from the table.
Parameters
time <value 1- 65535> − The ARP age-out time, in minutes. The
value may be set in the range of 1- 65535 minutes with a default
setting of 20 minutes.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To configure ARP aging time:
DGS3048#config arp_aging time 30
Command: 30
Success.
DGS3048#
show arpentry
Purpose Used to display the ARP table.
Syntax
show arpentry {ipif system | ipaddress <ipaddr> | static}
Description This command is used to display the current contents of the
Switch’s ARP table.
Parameters
<ipaddr> − The network address corresponding to the IP interface
name above.
static − Displays the static entries to the ARP table.
Restrictions None.
Example Usage:
To display the ARP table:
DGS3048#show arpentry
Command: show arpentry
ARP Aging Time : 20