Specifications

DGS-3048 Layer 2 Switch CLI Reference Manual
135
show authen application
Purpose Used to display authentication methods for the various applications
on the Switch.
Syntax
show authen application
Description This command will display all of the authentication method lists (login,
enable administrator privileges) for switch configuration applications
(console, telnet, SSH, web) currently configured on the Switch.
Parameters None.
Restrictions None.
Example usage:
To display the login and enable method list for all applications on the Switch:
DGS3048#show authen application
Command: show authen application
Application Login Method List Enable Method List
---------------- ------------------ ------------------------
Console default default
Telnet Trinity default
SSH default default
HTTP default default
DGS3048#
create authen server_host
Purpose Used to create an authentication server host.
Syntax
create authen server_host <ipaddr> protocol [tacacs+ | radius]
{port <int 1-65535> | key [<key_string 128> | none] | timeout
<int 1-30> | retransmit <int 1-10>}
Description This command will create an authentication server host for the
TACACS+ and RADIUS security protocols on the Switch. When a
user attempts to access the Switch with authentication protocol
enabled, the Switch will send authentication packets to a remote
TACACS+ or RADIUS server host on a remote host. The
TACACS+ or RADIUS server host will then verify or deny the
request and return the appropriate message to the Switch. More
than one authentication protocol can be run on the same physical
server host but, remember that TACACS+ and RADIUS are
separate entities and are not compatible with each other. The
maximum supported number of server hosts is 16.
Parameters server_host <ipaddr> - The IP address of the remote server host to
add.
protocol – The protocol used by the server host. The user may
choose one of the following:
 tacacs+ - Enter this parameter if the server host utilizes
the TACACS+ protocol.