Specifications

DGS-3048 Layer 2 Switch CLI Reference Manual
117
show 802.1x auth_configuration
Authenticator of the port to become Authorized. ForceUnauth forces the
port to become Unauthorized.
QuietPeriod − Shows the time interval between authentication failure and
the start of a new authentication attempt.
TxPeriod − Shows the time to wait for a response from a supplicant (user)
to send EAP Request/Identity packets.
SuppTimeout − Shows the time to wait for a response from a supplicant
(user) for all EAP packets, except for the Request/Identity packets.
ServerTimeout − Shows the length of time to wait for a response from a
RADIUS server.
MaxReq − Shows the maximum number of times to retry sending packets to
the supplicant.
ReAuthPeriod − Shows the time interval between successive re-
authentications.
ReAuthenticate: Enabled/Disabled − Shows whether or not to re-
authenticate.
Parameters
ports <portlist> − Specifies a port or range of ports to be viewed.
Restrictions Only administrator-level users can issue this command.
Example usage:
To display the 802.1x configurations:
DGS3048#show 802.1x auth_configuration ports 1
Command: show 802.1x auth_configuration ports 1
802.1X : Enabled
Authentication Mode : Port_based
Authentication Protocol : Radius_Eap
Port number : 1
Capability : None
AdminCrlDir : Both
OpenCrlDir : Both
Port Control : Auto
QuietPeriod : 60 sec
TxPeriod : 30 sec
SuppTimeout : 30 sec
ServerTimeout : 30 sec
MaxReq : 2 times
ReAuthPeriod : 3600 sec
ReAuthenticate : Disabled
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All