Specifications

DGS-3048 Layer 2 Switch CLI Reference Manual
115
Command: enable 802.1x
Success.
DGS3048#
disable 802.1x
Purpose Used to disable the 802.1x server on the Switch.
Syntax
disable 802.1x
Description
The disable 802.1x command is used to disable the 802.1x Port-based
Network Access control server application on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To disable 802.1x on the Switch:
DGS3048#disable 802.1x
Command: disable 802.1x
Success.
DGS3048#
show 802.1x auth_state
Purpose Used to display the current authentication state of the 802.1x server on the
Switch.
Syntax
show 802.1x auth_state {ports <portlist>}
Description
The show 802.1x command is used to display the current 802.1x
authentication state of the specified ports of the Port-based Network Access
Control server application on the Switch.
The following details what is displayed:
Port number − Shows the physical port number on the Switch.
Auth PAE State: Initialize / Disconnected / Connecting / Authenticating /
Authenticated / Held / ForceAuth / ForceUnauth − Shows the current state of
the Authenticator PAE.
Backend State: Request / Response / Fail / Idle / Initialize / Success /
Timeout − Shows the current state of the Backend Authenticator.
Port Status: Authorized / Unauthorized − Shows the result of the
authentication process. Authorized means that the user was authenticated,
and can access the network. Unauthorized means that the user was not
authenticated, and cannot access the network.
Parameters
ports <portlist> − Specifies a port or range of ports to be viewed.
Restrictions Only administrator-level users can issue this command.