Specifications

DGS-3048 Layer 2 Switch CLI Reference Manual
109
DGS3048#config igmp_snooping default host_timeout 250 state enable
Command: config igmp_snooping default host_timeout 250 state enable
Success.
DGS3048#
config router_ports
Purpose Used to configure ports as router ports.
Syntax
config router_ports <vlan_name 32> [add | delete] <portlist>
Description This command allows you to designate a range of ports as being connected
to multicast-enabled routers. This will ensure that all packets with such a
router as its destination will reach the multicast-enabled router − regardless
of protocol, etc.
Parameters
<vlan_name 32> − The name of the VLAN on which the router port resides.
[add | delete] – Specify whether to add or delete ports defined in the
following parameter <portlist>, to the router port function.
<portlist> − Specifies a port or range of ports that will be configured as
router ports.
Restrictions Only administrator-level users can issue this command.
Example usage:
To set up static router ports:
DGS3048#config router_ports default add 1-10
Command: config router_ports default add 1-10
Success.
DGS3048#
enable igmp_snooping
Purpose Used to enable IGMP snooping on the Switch.
Syntax
enable igmp_snooping
Description This command allows you to enable IGMP snooping on the Switch.
Parameters None
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable IGMP snooping on the Switch: