Specifications

DGS-3048 Layer 2 Switch CLI Reference Manual
106
16
BASIC IP COMMANDS
The IP interface commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
config ipif [{ipaddress <network_address> | vlan <vlan_name 32> | state [enable |
disable]} | dhcp]
show ipif {<ipif_name 12>}
Each command is listed, in detail, in the following sections.
config ipif System
Purpose Used to configure the System IP interface.
Syntax
config ipif System [{ipaddress <network_address> | vlan <vlan_name
32> | state [enable | disable]} | dhcp]
Description This command is used to configure the System IP interface on the Switch.
Parameters System - The IP interface name to be configured. The default IP Interface
name on the Switch is “System”. All IP interface configurations done will be
executed through this interface name.
<network_address> − IP address and netmask of the IP interface to be
created. The address and mask information may be specified by using the
traditional format (for example, 10.1.2.3/255.0.0.0 or in CIDR format,
10.1.2.3/16).
<vlan_name 32> − The name of the VLAN corresponding to the System IP
interface.
state [enable | disable] − Used to enable or disable the IP interface.
dhcp − Allows the selection of the DHCP protocol for the assignment of an
IP address to the Switch’s System IP interface.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the IP interface System:
DGS3048#config ipif System ipaddress 10.48.74.122/8
Command: config ipif System ipaddress 10.48.74.122/8
Success.
DGS3048#