Systems Switch User Manual

DGS-3024 Gigabit Ethernet Switch Manual
SNTP Settings
Time Setting
To configure the time settings for the
Switch, open the Configuration folder,
then the SNTP Settings folder and clic
k
on the Time Setting link, revealing the
following window for the user to config-
ure.
Figure 7- 39. Current Time: Status window
The following parameters can be set or are displayed:
Parameter Description
Current Time: Status
Current Time
Displays the time when the Switch was initially started for this session.
Time Source
Displays the time source for the system.
Current Time: SNTP Settings
SNTP State
Use this pull-down menu to Enabled or Disabled SNTP.
SNTP Primary Server
This is the IP address of the primary server the SNTP information will be taken from.
SNTP Secondary
Server
This is the IP address of the secondary server the SNTP information will be taken from.
SNTP Poll Interval in
Seconds
This is the interval, in seconds, between requests for updated SNTP information.
Current Time: Set Current Time
Year
Enter the current year, if you want to update the system clock.
Month
Enter the current month, if you would like to update the system clock.
Day
Enter the current day, if you would like to update the system clock.
Time in HH MM SS
Enter the current time in hours and minutes, if you would like to update the system clock.
Click Apply to implement your changes.
61