Systems Switch User Manual

DGS-3024 Gigabit Ethernet Switch Manual
4
CONNECTING THE SWITCH
This chapter describes how to connect the DGS-3024 to your Gigabit Ethernet network.
Switch to End Node
End nodes include PCs outfitted with a 10, 100, or 1000 Mbps RJ-45 Ethernet/Fast Ethernet/Gigabit Ethernet Network Interface
Card (NIC) and most routers.
An end node can be connected to the Switch via a Category 3, 4, 5, or 5e UTP/STP cable—for optimal performance, Category 5e
is recommended. The end node should be connected to any of the ports of the Switch.
Figure 4- 1. Switch connected to an End Node
The Link/Act LEDs light green when the link is valid. A blinking green LED indicates packet activity on that port. The Speed
LEDs indicate port speed and will light solid green for 1000 Mbps connections. They will remain off for 10 or 100 Mbps
connections.
9