Systems Switch User Manual

DGS-3024 Gigabit Ethernet Switch Manual
SNMP Host Table
Use the SNMP Host Table window to set up SNMP trap recipients.
Open the SNMP Manager folder, located in the Management folder and click on the SNMP Host Table link. This will open the
SNMP Host Table window, as shown below.
To delete an existing SNMP Host Table entry, click the corresponding
under the Delete heading.
To display the current settings for an existing SNMP Group Table entry, click the blue link for the entry under the Host IP
Address heading.
Figure 9- 12. SNMP Host Table window
To add a new entry to the Switch's SNMP Host Table, click the Add button in the upper left-hand corner of the window. This will
open the SNMP Host Table Configuration window, as shown below.
Figure 9- 13. SNMP Host Table Configuration window
The following parameters can be set:
Parameter Description
Host IP Address
Type the IP address of the remote management station that will serve as the SNMP host for the
Switch.
SNMP Version
• V1 - To specifies that SNMP version 1 will be used.
• V2 - To specify that SNMP version 2 will be used.
• V3-NoAuth-NoPriv - To specify that the SNMP version 3 will be used, with a NoAuth-
NoPriv security level.
• V3-Auth-NoPriv - To specify that the SNMP version 3 will be used, with a Auth-NoPriv
security level.
• V3-Auth-Priv - To specify that the SNMP version 3 will be used, with a Auth-Priv security
level.
Community String
or SNMP V3 User
Name
Type in the community string or SNMP V3 user name as appropriate.
To implement your new settings, click Apply. To return to the SNMP Host Table, click the Show All SNMP Host Table Entries
link.
115